Rheavendors Group barista XX, Руководство по установке и обслуживанию

Страница: 32 / 49

in this ensemble of parameters, key “2”, you can set up some
counters to trigger an alarm after a programmable number of
events (press “4” and “5” to set up and PROG to store):
- dispensing cycles before having to replace the cartridge of the
external filter, if any; as soon as 500 dispensing cycles are left,
the display will show “change water filter” and as soon as the
decounter has reached 0, it will display “out of service water
filter”, thus inhibiting the operation of the machine;
- espresso dispensing cycles before having to service the coffee
unit (see 12.02.); as soon as 5 dispensing cycles are left, the
display will show “make brewer cleaning” and as soon as the
decounter has reached 0, it will display “out of service cleaning
brewer”, thus inhibiting the operation of the machine;
- espresso dispensing cycles before having to empty the grounds
container (see 13.02.); as soon as the decounter has reached 5,
it will display the message “remove coffee grounds” until the
decounter has reached 0, thus inhibiting the operation of the
machine and the display will show “out of service coffee
grounds”;
- the maximum credit you can load from the RFID card;
- 0 for each coin (from A to J) that can be accepted when the RFID
card is available;
- 0 for each coin (from A to J) that can be accepted when the RFID
card is not available;
choose the option “data” to enable the display to show the data of
the dispensing cycles you have performed in succession, just as in
09.01.h.;
option not to be considered;
choose this option and press “1”, “2”, or “3” to enable the vending
machine to dispense a pre-fixed water quantity to wash the
corresponding circuit (see 08.03.);
the display shows:
to carry out the same functions as those described by point
09.01.n.;
the values of the variables composing the machine programming
(configuration) can be transferred to an external support, i.e. the
flash key; to transfer the machine parameters to the key:
- power off the machine;
- open the door;
- insert the flash key into the cover slot of the machine (see
05.17.);
- power on the machine;
- the display shows:
- press “2”
- and wait for the display to show:
- power off the machine and remove the flash key;
now, the flash key contains all the parameters typical of the
machine from which they have been fetched. If you wish to
programme another vending machine with these data, the previous
procedure can be repeated by pressing key “1” instead of “2”: the
information will be transferred from the flash key to the vending
machine; both procedures will not alter the data contained in the
supports from which they have been fetched;
09.01.n. maintenance
09.01.o. rfid card
09.02. “data”
09.03. “test”
09.04. “clean”
09.05. “maintenance”
09.06. data support
programmazione
by
MAN1920124 rel. 01 dated 23.09.2011 page no. 32 of 48 pages
[ 00] 00
water filter cnt
0.00
max credit card
card 0=acc.
coin A N
[ 00] 00
dec. cof. brewer
[ 00] 00
dec. cof. grounds
no card 0=acc.
coin A N
cleaning N
sel. 1-2-3
cleaning
2 from VMC to key
1 from key to VMC
wait ………
END PROGRAMMING