Rheavendors Group barista XX, Руководство по установке и обслуживанию

Страница: 36 / 49

replace the gasket at the base of the mixing bowl of the mixer;
remove the mixer motor fan by pulling it; replace the gasket of the
mixer motor shaft “I”;
disassemble the products canister from the machine; empty them,
disassemble them in their basic components and wash them
carefully “L”;
remove the water transport tubes from the boiler at the back of the
mixer surface, disassemble the mixing bowls, unscrew the two side
screws intended to fasten the surface, tilt and pull it, remove the
aspiration drawer; wash it abundantly with lukewarm water;
empty the boiler by means of a drain pipe; extract it from the
machine, remove the cover and wash the tank by removing any
solid residue that may have built up at the bottom;
remove any calcareous deposit from active elements: temperature
probe, heating element, level probes, the shafts of rotary
pumps, …;
make sure that the water transport tubes are intact and that they
have kept their transparency, replace them, if necessary;
- replace the upper and lower pistons gasket;
- replace upper and lower filters;
- check the status of the brewing chamber;
disassemble the heat exchanger (see 05.36.) and separate it from
the three-way solenoid valve block; clean the espresso outlet water
circuits; check the drain of the solenoid valve third way by
removing any trace of residue; empty and clean the air-break tank;
if the vending machine should be inactive for a long period, please
act as follows:
- in E machines, perform the uninstall cycle (see 09.01.e.);
- in I machines, set the boiler water temperature to zero;
- detach the water and energy supply;
- in I machines, empty the boiler;
- empty the liquid waste tray and the internal water tank;
- empty and clean the product canisters;
- clean the internal and external surfaces by using a wet piece of
cloth;
- cover the machine by means of a cloth;
- store it in a sheltered place, at a temperature not below 5
°
C, at
a relative humidity not above 80%;
if you should definitively set the vending machine out of
commission and provide for the disposal of some parts thereof,
after having carried out the operations above, disassemble the
vending machine by separating every single component and
subdividing the parts according to the nature of materials; the
applied symbol means that the components of the vending machine
shall be not processed as home rubbish, but delivered to the
collection points capable of recycling electric and electronic
equipment; refer to the 2002/96/EC Directive and to the relative
rules;
the complete text of the European directive about this specific
subject-matter is made available on the Internet site:
http://eur-lex.europa.eu/
directive 2002/96/EC of 27/01/2003
10.03. yearly
dispensing system
products canister
powder aspirator drawer
boiler
silicone tubes
in E machines
coffee brewer
heat exchanger
10.04. out of order
temporary
definitive
manutenzione
MAN1920124 rel. 01 dated 23.09.2011 page no. 36 of 48 pages
by
L
M
I