82
• When the filament is marked, feed in precisely 50 mm. For this,
move the mouse over the arrow at the lower left in the right control
(see red arrow). When the mouse pointer is all the way at the bot-
tom (see arrow tip of the red arrow) and the middle shows 50, click
precisely once.
• The filament motor now conveys precisely 50 mm filament and
then stops again.
If the infeed does not react when you click the arrow, send
the command "
G92 E0
" to the printer (enter the command
in the field "
G-Code
" and click "
Send
"). Then try it again.
• Now measure the remaining distance between the
ball bearing holder and the mark just as you did
when marking before.
• In our example, 46.28 mm are left.
To make the calculation example on the
next page more easily comprehensible, we
round down the value to 46 mm. When you
perform the calibration, use the precise
value for the calculation, however.
