Renfert AUTO spin, Инструкция по эксплуатации

Страница: 23 / 174

EN
6.3 Spare parts
You can find components subject to wear and the spare parts on the spare part
list in the internet at www.renfert.com/p918 �
Enter the following item number: 18600000�
The components excluded from the warranty (such as consumables or parts sub-
ject to wear and tear) are marked on the spare part list�
Serial number and date of manufacturing are shown on the type plate of the unit�
7 Troubleshooting
Error Cause Solution
The operating indicator (3)
flashes.
• The drill motor is not in the starting
position�
• Press both operating keys until the drill motor has
reached its starting position (see Chapter 4�5)�
The drilling process has been
interrupted and the operating
indicator (3) flashes.
• Drill not adequately tightened�
• Drill broken�
• Press both operating keys until the drill motor has
reached its starting position (see Chapter 4�5)�
• Retighten screw of fastening (see Chapter 6�2)�
• Change the drill�
Plate holder moves during drill-
ing, lifts up.
• Insufficient magnetic force due to
plastic chips between the magnet
and the plate holder�
• Remove plastic chips on the drilling table and
under the plate holder�
Drilling depth changes.
• Restraint of the stop screw is no
longer sufficient.
• Use new stop screw�
After a drill change, the drilling
depth deviates significantly
from the previous depth, even
though a drill of the same
length is used.
• Restraint of the stop screw is no
longer sufficient.
• Use new stop screw�
Drill cannot be removed by
hand.
• Drill was not sufficiently tightened
and seized up in the drill chuck�
• Use a pair of pliers to remove the drill� Do not
reinsert drill, discard drill�
8 Technical Data
Nominal voltage 230 V 120 V 100 V
Permissible mains voltage: 220 - 240V 120 V 100 V
Mains frequency: 50 / 60 Hz
Power consumption:
- Between the holes:
- During the drilling, approx�:
1�5 W
115 W
Laser:
- Laser class:
- Wavelength:
- Output power P0, max�:
2
630 - 680 nm
< 1 mW
LpA *): < 70 dB (A)
Dimensions
(width x height x depth):
180 x 368 x 275 mm
[7�1 x 14�5 x 10�8 inch]
Permissible drill shaft diameter: 3�00 mm + 0 / - 0�006 mm
Total drill length (min� - max�): 38 - 40 mm [1�5 - 1�57 inch]
Weight: 7�6 kg [16�8 lbs]
*) Sound pressure level in accord� with DIN EN ISO 11202
- 9 -