Reliance electric DC2 VS series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 37 / 56

46
Startup and Adjust the Controller
NOTE: This procedure covers Speed Control, Process Control, and
Torque Control controllers. Therefore, you will find references to
speed, process or torque" when the type of control is important.
1. Verify that the circuit board pots (Figure 41) are set as indicated
below:
With Speed Control models:
D MAX - fully CCW
D MIN - fully CCW
D IR DROP - fully CCW
D CURRENT LIMIT - 50% of full scale
D RATE - 75% of full scale (A clockwise rotation decreases
acceleration time and increases rate).
D PI GAIN (on Process Control models only)
- fully CCW
D PI BIAS (on Process Control Models only)
- fully CCW
With Torque Control models:
D MAX - fully CCW
D MIN - fully CCW
D IR DROP - fully CCW
D CURRENT LIMIT - 50% of full scale
D RATE 1 and RATE 2 - 75% of full scale
D PI GAIN (on Process Control models only)
- fully CCW
D PI BIAS (on Process Control models only)
- fully CCW
D SPD LIM - fully CCW
2. Set the operator's speed or torque potentiometer fully CCW.
3. If your controller includes process control, push the
Automatic/Manual switch to Manual; otherwise proceed to Step 4.
4. If your controller includes a Forward/Off/Reverse switch, set the
switch to the Forward position and proceed to Step 5.
DANGER
THE REMAINING STEPS ARE MADE WITH POWER ON. EXERCISE EXTREME
CAUTION AS HAZARDOUS VOLTAGE EXISTS. FAILURE TO OBSERVE THIS
PRECAUTION COULD RESULT IN SEVERE BODILY INJURY OR LOSS OF
LIFE.
5. Apply AC input power.