Pg. 16
Doc ID: 191-7803A
Doc Rev: 011918
Setting the installed gap and checking Free Play Gain is a 4-
step process. It is important to follow each step to ensure
that your new clutch functions as designed.
Step 1: Set the installed gap
Do not ride your bike without the adjusting the installed
gap. You will not be able to disengage the clutch until
you set the installed gap.
a)
With the bike standing up, locate the adjuster screw in
the center of the adjustable slave cylinder.
b)
With the O-ring showing, use a 4 mm hex key to turn
the adjuster screw clockwise until it stops under light
pressure. This is your “starting point.”
Note:
The resistance you feel is where the throw-out begins
to lift the pressure plate. Finding the right starting point may
take a few tries, but you will feel a noticeable change in
turning effort once you reach that point. Stop when you feel
the pressure increase.
The “starting point” will change a
s the
clutch pack wears over time.
