Doc ID: 191-7803A
Doc Rev: 011918
Pg. 17
c)
Once you have found the starting point, note the
position of the hex key using the tick marks on the slave
cylinder housing and the small etch mark located on the
screw. You will begin here to adjust the installed gap.
d)
Use a 4 mm hex key to turn the adjuster screw
clockwise 1 full turn from your starting point.
This may
NOT be your final setting
, but it is a beginning
adjustment for finding the correct setting.
e)
Continue with Step 2 to check for Free Play Gain.
Step 2: Learn how to check Free Play
Gain
If you are familiar with Free Play Gain, check for Free Play
Gain then skip to Step 3 -
“Break
-
in the new clutch.”
If Free Play Gain is new to you, follow the instructions below
to help you learn this important step. You can also view the
video entitled “How to Check Free Play Gain”
on our website
at
www.rekluse.com/support/videos
.
Free Play Gain is different from the “normal” free play you
are used to with your stock clutch. With the Rekluse auto
clutch, Free Play Gain is the result of the EXP disk
expanding and lifting the pressure plate to engage the
clutch.
Free Play Gain happens when the engine’s RPM increases
from idle to above approximately 5,000 RPM and the EXP
Use the tick marks on the cylinder
and the etch mark on the screw to
remember the starting point for
adjusting the gap.
