Doc ID: 191-7803A
Doc Rev: 011918
Pg. 33
Changing the EXP springs
Use the following steps to change the EXP spring
configuration. It is
NOT necessary
to disassemble the EXP
halves to change springs!
1. Using a flat-blade screwdriver, push the ¼ turn pin in far
enough to clear the opposite side of the EXP to unlock
the pin.
2. With the pin still pushed past the base, turn 90° to
remove the pin and spring.
3. Remove the remaining 2 pins and springs from the same
side of the EXP base.
4. Drop a new spring into the spring slot on the base, then
add the ¼ turn pin.
5. Push the turn pin in far enough to clear the base, then
turn 90° and release the pin. The pin should sit almost
flush with the EXP base.
6. Flip the EXP friction disk over, and repeat on the other
side depending on engagement preference.
7. If you need to disassemble the EXP disk, you can watch
the video on our website under Tech Tips at
www.rekluse.com/support/videos/atv-mc-support-videos.
