Doc ID: 191-7803A
Doc Rev: 011918
Pg. 29
Always soak friction disks or EXP bases in oil for at least 5
minutes before installing.
·
Replace friction disks if they measure below specifications
listed on the attached Setup Sheet or if the disks are
glazed and/or burnt.
·
Replace the drive plates if they show signs of excessive
heat.
Disk inspection examples
When inspecting the clutch pack, the following pictures can
be used as a reference.
These are best viewed in color by
viewing this install document from
www.rekluse.com/support.
Drive Plates
–
If the clutch pack is getting high amounts of
heat, purple, blue, or black color can be seen on the drive
plate teeth. See pictures below. Not all drive plates look the
same and may look different than pictured.
Normal Heat
High Heat
Excessive Heat
(Blue)
(Black)
