Doc ID: 191-7803A
Doc Rev: 011918
Pg. 25
Note:
Your clutch pack will expand with heat, so final
adjustment to Free Play Gain should be made when the
bike is warm. Remember not to ride without sufficient Free
Play Gain.
4 strokes only:
It is normal for some clutch debris
to be produced during break in.
Following break-in,
remove and inspect the OE oil filter. Clean or replace it
if necessary. Remove and inspect any additional oil
screens for clutch debris and clean or replace if
necessary. Change the oil after break-in.
Do not perform 3
rd
gear starts with this product.
Starting in 3
rd
gear will burn up the clutch and decrease
the performance of this product in a short amount of
time.
Step 4: Adjust the installed gap and
Recheck Free Play Gain
Once you have learned how to check Free Play Gain, you
need to finish adjusting the installed gap, then recheck the
Free Play Gain until the clutch lever moves only 1/8” (3 mm).
The gap is adjusted by turning the slave cylinder screw.
a)
With the bike running and in
NEUTRAL
, locate the
adjuster screw in the center of the adjustable slave
cylinder.
b)
Use a 4 mm hex key to turn the adjuster screw
clockwise 1 tick mark from the last setting, then
recheck Free Play Gain.
