REI TALAN 3.0, Руководство пользователя

Страница: 26 / 82

TESTING CONCEPTS AND RECOMMENDED TEST SEQUENCE
26
The TEST TYPEs selected when pressing BLOCK and PHONE can be changed for this TALAN. The
TEST TYPEs for this TALAN are remembered through power cycles.
To change the
TEST TYPEs selected when pressing PHONE on the Sequence Mode DMM screen,
do the following:
Access the Test Type pair/wire selection menu by pressing the CUSTOM button
Setup the TEST TYPE configuration you want for PHONE for each TEST TYPE
Press Save As PHONE Test Types .
Likewise,
To change the
TEST TYPEs selected when pressing BLOCK on the Sequence Mode DMM screen,
do the following:
Access the Test Type pair/wire selection menu by pressing the CUSTOM button
Setup the TEST TYPE configuration you want for BLOCK for each TEST TYPE
Press Save As BLOCK Test Types .
If at any time you want to go back to the factory settings as it was shipped from REI for
PHONE
and BLOCK , then press the Restore BLOCK/PHONE to Suggested Defaults button.
The
PHONE and BLOCK Test Type settings are retained during power cycles.
The Suggested Defaults cannot be changed.
Test Type Configuration Tips
It is not advisable to perform a Resistance test on pairs that have not been checked for VDC
because the TALAN applies DC Voltage to perform the Resistance test. Therefore, when you
select a Resistance test combination that has a pair that is not going to get tested due to the
current
TEST TYPE selected for VDC TEST TYPE , the TALAN will automatically change the VDC
TEST TYPE to the same TEST TYPE as you selected for the Resistance TEST TYPE . A warning
message will be shown reminding you that this change automatically occurred to the VDC TEST
TYPE .
For example, assume you do the following:
Set VDC TEST TYPE to Balanced Pairs
Then set Resistance TEST TYPE to All Pairs
The TALAN will automatically change VDC TEST TYPE to All Pairs .
A Warning Message will appear.
However, the TALAN will allow you to select a lower set of pairs for VDC once the
Resistance
TEST TYPE is set.
For example, assume you do the following:
Set Resistance TEST TYPE to All Pairs ,
Then Set VDC TEST TYPE to Balanced or None .
The TALAN will permit this change, because it assumes that your selection is based on
knowledge of the state of the wires/pairs, however a Warning Message will appear.