Regulus KPC1-BP, Инструкция по установке и эксплуатации

Страница: 11 / 26

11
│
2.4 Collector mounting
• collectors must be covered during mounting
• insert safety retaining brackets into the bottom rail, 2 brackets per collector
• insert the retaining brackets into the bottom rail about 100 mm from the collector edge
• lay the
fi rst collector on the rails and align it. The distance between the bottom edge of the collector and of the
base rail depends on the design and size of the retaining brackets. The collector bottom edge is by 75 mm
lower. The distance between the collector edge and the end of the bottom rail is B = 35 mm.
• Align the rails so that they lie in parallel to roof tiles. The diagonal between the rails must be of the same
length:
D1 = D2
Then tighten the nuts on fi xing screws.
04 – Aluminum rail
14 – Safety retaining bracket
Pic. 12: Inserting safety retaining brackets
14
04
14
Pic. 11: Alignment of base rails
parallel
D1
D2