Regulus KPC1-BP, Инструкция по установке и эксплуатации

Страница: 18 / 26

│
18
5 Hydraulic Connection
5.1 Collector connecting
For collector mounting follow the instructions in chapter 2.4. Fasten the fi rst collector and lay the following one
next to the fi rst one, maintaining a suf fi cient gap. Then put on the threaded fi ttings and push the collector to the
already mounted one until stop. Hold the fi tting with a spanner to prevent turning and tighten the nuts.
Continue in the same way with further collectors. Put the insulation on the threaded fi ttings only after
a successful leak test.
5.2 Collector interconnecting
Pic. 25: The best method of collector interconnecting
Pic. 24: The picture shows how to connect the upper threaded fi ttings. Use the same method also for the lower
fi ttings.
INLET
OUTLET
Based on the tests done, also the below shown one-sided connection can be recommended but only if no
more than 3 collectors are connected with max. fl owrate of 1 l/min./coll.
Pic. 26: One-sided connection
The inlet of colder fl uid
(blue) is the lower one, the
outlet of warm
fl uid (red) is
on the same side, the upper
one. Both the connections
shall be plugged at the other
collector end.
OUTLET
INLET
PLUG
COMPENSATOR
PLUG