Regency Horizon HZ40E, Инструкция для владельца и по установке

Страница: 52 / 72

52 |
Regency Horizon® HZ40E-10 Gas Fireplace
|
52
installation
Read the instructions below carefully and refer to the images. If the logs are broken do not use the unit until they are replaced. Broken
logs can interfere with pilot operation.
Improper positioning of the logs may create carbon build-up and can alter the unit's performance which is not covered under warranty.
*Dark brown paint is included if touch ups are required.
1 Rear Log
2 Left Log
3 Right Log
4 Left Cross Log
5 Right Cross Log
6 Front Left Log Piece
7 Front Right Log Piece
Lava embers
Pilot Hood - HZ54E only
Log placement template - HZ54E /HZ40E
Magnets x 2
1
3
5
2
4
6
7
1 . S hut off gas and electrical supply, allow unit to cool to room temperature.
2 . Remove fl ush glass door (see manual).
3 . Carefully remove the logs from the packaging and unwrap them.
The logs are fragile, handle with care -never force into position.
4 . Ensure glass crystals are installed on the burner.
HZ54E = 2lbs HZ40E=1.5lbs
5. HZ54E only - Remove existing pilot hood - replace with pilot hood
provided with log set.
HZ54E - existing Pilot
Hood
HZ54E - new Pilot
Hood
Top View - showing both HZ54E/HZ40E cut
template out along dotted line
6 . Clip on the log guides - position approximately 5" on either side of the
outside edge of the pilot hood.
7
. Install Rear Log (1), by positioning cut out over pilot hood - ensure
cut out is centered.
8
. Push the rear log gently back, until it hits the log guides.
9 . Locate provided log placement template - identify unit required before
cutting template out along dotted line. Slide template on fi rebox fl oor
up to the edge of the burner, ensure L and R sides are in the correct
position. Secure template in place with magnets (supplied) on each side.
Log guides
Log 1 in position
1
1
These cut lines for HZ40E only
OPTIONAL DRIFTWOOD LOG SET INSTALLATION