Regal 38 SAV 2019, Руководство пользователя

Страница: 123 / 297

123
Operating Vacuum Style Toilet
To use toilet first make sure the 12 volt breaker is
activated at the main control panel. Remember even
though you are using dock side water the heads
draw water via the fresh water system through the
potable water tank.
The wall control switch
is used to add water
to the bowl and to
flush the toilet. Select
cycle information is
noted here. For more
complete information,
refer to the toilet vendor
information located in
the information packet.
1. To add water (est. 17
ounces each cycle ) to
the bowl press the add water button momentarily
and release. The system prevents overfilling the
bowl.
2. To flush the bowl press the flush button
momentarily and release. The attached bowl motor
will macerate the waste and flush it. The cycle ends
with a small amount of water being added to the
bowl to help prevent odors. This completes the
minimal water usage flush cycle.
Wall Control Panel Blue Backlighting Description:
• The holding tank icon in the lower right hand
corner of the control panel is not lighted. Toilet
system is off or not receiving power.
• The holding tank icon is normally green. This
means the holding tank is less than full.
• The holding tank icon is red. The holding tank is
full or near full with the flush lockout (prevents
Flush operation when holding tank is full)
activated.
• Tank icon flashes.
• Sleep mode (non-use for 8 hours) causes the
lights to go out. Pushing the fill or flush button
momentarily will return lighting cycle.
Single Flush Override of Flush Lockout
1. If the holding tank is full the flush lockout cycle will
not allow the bowl to be flushed and the flush button
will be lighted red.
2. For emergency use only the flush button can be
held for 8 seconds and a flush will occur. This can
be accomplished because the full sensor connected
to the holding tank is usually placed a bit below the
actual full capacity of the tank. Flushing more than
5 times using the override feature may force waste
into plumbing system. Regal is not responsible for
damage to equipment, injury or death due to overflow
of waste when the flush lockout is overridden.
POSSIBLE OVERFLOWING
OF THE WASTE HOLDING TANK
CAN OCCUR DUE TO USING
THE SINGLE FLUSH OVER-RIDE FUNCTION.
FOR EMERGENCY USE ONLY.
CAUTION