Regal 38 SAV 2019, Руководство пользователя

Страница: 71 / 297

71
1. It is possible that one of the DC
distribution system amplifier or steer-
ing pump breakers may trip from
long-term arcing and heat.
To trip and/or reset this style of
breaker do the following:
A. Take a small slotted in-
sulated screwdriver from
your on-board tool kit and
insert it in the breaker slot
until it trips. You will hear a
snapping type noise. See
the illustration.
B. Notice that the breaker
has pushed outward from
its original flush position
indicating the breaker has
been tripped. See the illus-
tration.
C. To reset the breaker use
your finger to press the
breaker down until it locks
in the “on” position. You
may hear a slight noise.
This is normal. The icon
display should be lighted after this procedure. See
the illustration.
DC Distribution Panel-Resetting Breakers 2. Breaker will not reset- Replace the breaker.
Contact the nearest Regal yacht dealer for re-
placement parts.
3. Breaker continues to “trip”. Check the affected
equipment to determine if it is responsible for the
excessive draw to trip the breaker. If the equipment
is determined to be within specifications check for
a “short” in the wiring circuit. Also, the breaker may
be faulty. Contact the closest authorized Regal
dealer for service and parts.
Note: It is possible under certain circumstances
that a breaker may preform a “soft” trip on a circuit.
The breaker may not appear to be in the tripped
position but at this point current to dedicated com-
ponents in this particular case is interrupted.
It is recommended to turn any equipment on the
circuit to the “off” position until the breaker is reac-
tivated. In this situation insert the insulated screw-
driver blade into the breaker slot until it fully trips
the breaker. Then reset the breaker by pushing the
breaker down until it clicks into place. At this point
energize the circuit by activating components or
equipment.