Reer SAFEGATE MAL2P TRX, Инструкция по установке, эксплуатации и обслуживанию

Страница: 30 / 82

REER S.p.A. - Via Carcano, 32 - 10153 Torino, Italy - Internet: www.reersafety.com - e-mail: info@reer.it
30
8541205 - rev
.1 - 02/09/2019
Electrical connections/Operating modes
Table 1
MAIN MALE CONNECTOR - M12 - 12 PIN
PIN COLOUR SIGNAL IN/OUT DESCRIPTION ELECTRICAL LEVEL
1 Brown 24VDC - POWER SUPPLY 24 VDC -
2 Blue 0VDC - POWER SUPPLY 0VDC -
3 White OSSD1 Output STATIC SAFETY OUTPUTS PNP active high
4 Green OSSD2 Output
5
Pink
PE
- EARTH CONNECTION -
6 Yellow SEL_A Input MUTING CONFIGURATION Refer to
“SELECTION OF OPERATING
MODES”, page 32
7 Black MUT_ENABLE Input
EXTERNAL MUTING
ENABLE
Safegate considers the muting cycle correct if it
detects a “MUTING ENABLE” signal rising edge
before the use of the sensors
8 Grey EDM Input FEEDBACK K1/K2 External contactors feedback ”EDM”, page 33
9 Red OVERRIDE2 Input OVERRIDE REQUEST Refer to the section “OVERRIDE”, page 34
10 Violet
OVERRIDE1
Input
OVERRIDE REQUEST Refer to the section “OVERRIDE”, page 34
RESTART RESTART INTERLOCK
Refer to the table “RESTART (MANUAL
OPERATION)”, page 35
11 Grey/ Pink SEL_B Input MUTING CONFIGURATION Refer to the section
“SELECTION OF
OPERATING MODES”, page 32
12 Red/Blue STATUS Output SYSTEM STATUS PNP active high
Î
When connecting high inductive loads to OSSDs, use suitable voltage suppressors on the outputs.
In free protected area conditions, the Active Element provides a voltage of 24VDC on both outputs.
Therefore, the established load must be connected between both output terminals and the 0VDC.