![RED A10-UHE Скачать руководство пользователя страница 54](http://html1.mh-extra.com/html/red/a10-uhe/a10-uhe_installation-and-user-manual_1427134054.webp)
User’s Manual Code 001
Page 10-51
Rev 0819
10
INSTALLATION OF HEAT PUMP WATER STORAGE TANK
The following instructions must be read prior to the installation of the heat pump DHW water
storage tank. The installer should be aware of the duty of care to ensure all aspects of the
installation comply with all current regulations and legislation.
All electrical work should only be undertaken by a competent electrician and it is their
responsibility to ensure that any work is carried out is down in accordance with the latest
regulations.
10.1
Heat pump cylinder location
Prior to installation the hot water storage tank should be handled with care and stored upright
in a dry location. For manual handling, pay heed to the empty tank weight as per section 0.
To gain optimum hot water performance, consideration for the relative position of tank to
the distribution manifold and hot water outlet. These should be as short as possible which
will reduce both temperature and flow losses. To achieve the tank performance listed in the
technical specification the following requirements must be met.
a.
The heat pump cylinder must be located on a solid level base, free from debris and
should cover the entire base of the tank.
b.
The base must be capable of supporting the total weight of the total filled tank as per
Table 3.
c.
The installation site should be indoors and in a frost-free room and protected from
direct sunlight.
d.
The tank must be located a minimum of 1 meter from > 80°C (electric / gas heater,
open fire and flue / chimneys).
e.
Routing of the overflow pipe should be considered to allow it to be safely conveyed
and discharged.
f.
For future servicing and maintenance requirements the tank should be positioned in
such a way that allows for components to be inspected removed and replaced if
necessary, as per Figure 24.
Содержание A10-UHE
