© REA Elektronik GmbH, D-64367 Mühltal / Germany
+49 (0) 6154 638-0 • Fax - 195 Thermal printer TD-GPT-U -
February 2012-
Page 4 of 18
REA
Elektronik
GmbH
Rationalisierung
•
Entwicklung
•
Automation
Elektronische Geräte und Systeme
2
Security hints
The device may be opened or repaired by authorized personal only. Never open the device or carry out repairs
yourself. Always contact authorized technical service. Service information is in the chapter "Service and
Maintenance".
Before charger is used and connected to the printer it must be verified that the mains power voltage matches to
the specification of the printers power supply. The specifications are printed on the type label as well as in the
chapter with technical data.
The peripheral devices that are connected to the interfaces and the DC circuits of this device have to meet the
requirements for safety extra-low voltage (SELV) in accordance with EN/IEC 60950. Switching off the device
does not completely disconnect it from the power supply. The printer is only disconnected completely, if the
power supply is removed from the mains power socket. The power supply cable needs to be placed without
letting people stumble over the cable. Further it must be taken care of not damaging the cable.
During operation, surfaces in the surrounding area of the print head may heat up. Therefore, direct contact with
the print head must be avoided to prevent burning accidents. Thermal sensitive parts should not be placed close
to the thermal printing head. Avoid constant high humidity and condensing humidity. The device needs to be
protected against getting wet and from contact with solvents and any chemicals (except
isopropanol to c
lean
the print head). Use spare parts and accessories supplied or authorized by REA Elektronik GmbH. The use of
unauthorized parts or accessories may affect the function and safety of the device. All parts included are listed in
the chapter "Packing List", while the original accessories are listed in the chapter "Parts and Accessories".
It is no longer save to use the printer if
-
The housing has been damaged
-
Moisture reached the inside of the device
-
Smoke is coming from the inside of the device
-
The power supply cable is damaged
-
The device stops working properly
Turn off the device immediately, when a failure occurs as mentioned above and contact REA Elektronik GmbH
for service. More information is in the chapter "Service and Maintenance".
Any warranty and product liability voids, if the printer has not been used in accordance with the instructions in this
operating manual.
There is risk of explosion and destroying the printer in case of incorrect battery exchange.
In case of any damages or failures the printer must not be used anymore to avoid more damages and damages
to connected devices.
