© REA Elektronik GmbH, D-64367 Mühltal / Germany
+49 (0) 6154 638-0 • Fax - 195 Thermal printer TD-GPT-U -
February 2012-
Page 13 of 18
REA
Elektronik
GmbH
Rationalisierung
•
Entwicklung
•
Automation
Elektronische Geräte und Systeme
Font #:
1
Available settings:
1, 2, 3, 4
Text orientat:
Text mode (D0)
Available settings:
Text mode (D0), Data mode (D1)
Char. size:
W0/H0
Available settings:
W0/H0, W0/H1, W0/H2, W0/H3, W1/H0, W1/H1, W1/H2, W1/H3
Char. spacing:
0
Available settings:
0, 1, 2, 3, 4, 5, 6, 7
Print width:
48 mm
Available settings:
48 mm .... 32 mm
For the REA TD-GPT-U the settings shown here must be used. If settings are changed the report print may be
incorrect or is not possible.
10
LED Status
LED "STATUS" (green)
The STATUS LED flashes slowly green if printer is ready and no fault is detected. It will flash red in regular
intervals in case of a fault. During fast charging, the STATUS LED will flash green in regular intervals, while it
permanently on (green) during trickle charge.
11
Error Detection and Recovery
If there is a problem with the printer it does not necessarily mean that the printer is faulty. Some problems can be
solved by the operator.
The following tips are intended to give the operator some assistance for this.
Hints for error recovery
Hardware-RESET
: Triggered by holding down the OFF/NEXT key for more than 3 seconds.
This causes the printer to be set to the parameters in the batch file TINIT-F or TINIT-E (printer internal)
Test print:
Is triggered by holding down the FEED key for more than 3 seconds after switching on (disable test
print with the OFF/NEXT key).
Hex dump mode
: Is triggered by holding down the FEED key for more than 3 seconds after switching on while
no paper is inserted. After the paper has been inserted, the printer prints the data it receives as hexadecimal
digits together with the appropriate ASCII interpretation. This shows the complete binary data stream the printer
receives from the USB interface. To disable the hex dump mode the paper must be removed and the Feed key
has to be pressed for 3 seconds or longer. The printer reinitializes to the last settings.
