Door control
FireProV2
Manual
Please keep this manual with attachments carefully!
18
For doors with reflective surfaces:
When placed before the door (without a door function), it can prevent the door from closing
properly/regularly. This can happen at reflective doors. By the self-regulation in the light curtain,
the light level of the transmitter will be lowered when the door is closed. At the moment the door
opens, the light level is too weak to reach the receiver. This disables the receiver as if the light
beam is interrupted.
At the
open Door
, connect
the Sync (white) wires briefly (less than 1 second) to the + 24VDC.
At the receiver the green LED lights up continuously and the red flashes for several seconds.
After a maximum of 10 seconds, the red LED will remain off. The learning process is over.
The light curtain software then remembers the light values at open door and the light curtain also
no longer automatically adjusts itself after this setting.
This is to prevent the light reflections from leading to unwanted reversing of the door.
Note: This only works with a disabled door function.
During the learning, there should be no interruption of the light curtain!
If this happens, the procedure can simply be repeated
.
Reset to factory defaults:
Connect the Sync (white) wires for at least 15 seconds and up to 25 seconds with the + 24VDC.
Advice:
After all the settings, remove the power from the light curtain and put it back on. The light curtain,
with all the right settings, sets itself off to the correct luminosity.
Error messages:
Transmitter:
No LED lights
Check power supply
Green lights > Yellow flashes every time 3x
Receiver power supply is connected the wrong
way
Only yellow flashes 3x
White sync cables not (properly) connected
Receiver:
No LED lights
Check power supply
Red LED flashes every 2x
O
utput cable incorrectly connected or defective
Both:
If all LED’s on both transmitter and receiver are blinking, the light curtain must be replaced.
