Rapid Technic Orbito, Руководство по эксплуатации

Страница: 223 / 244

223 Machine No. from 10005200
EN
5.16 Calibrating the machine configuration
Why: the curve behaviour changes, depending on axle width and handlebar length.
When: after having changed the track width and/or axle width, observe the handlebar length (long
and short).
Configuration = x Handlebar length Axle width
* 4
long Standard
6 long Wide axle
8 long Broad-gauge axle
10 short Standard
12 short Wide axle
14 short Broad-gauge axle
* factory setting
Calibration process
LED flashes green
ͻ
Switch ignition on
ͻ
Move both steering levers up to the stop and hold
ͻ
Switch the "Steering type" switch back and forth until the LED flashes green briefly and then red slowly
Notice:
Settings can only be performed within the first 20 seconds after switching on the ignition
ͻ
Let go of both steering levers
LED flashes green
briefly and then red
slowly
ͻ
Actuate the dead man handle x times, according to the desired configuration
ͻ
Switch the "Steering type" switch back and forth until the LED lights up in green or red - Calibration
process completed
Notice:
Without actuating the "Steering type" switch, the LED display changes automatically after
20 seconds and the calibration process is completed.
LED lights up in red
ͻ
Fault; calibration was not successful, a
fault occurred
ͻ
Switch ignition off and repeat the
calibration process
LED lights up in
green
ͻ
Calibration was successful
ͻ
Switch ignition off