Rapid Technic Orbito, Руководство по эксплуатации

Страница: 218 / 244

218 Machine No. from 10005200
EN
5.8 Coupling and uncoupling attachments
Coupling
• Clean connection flange of machine and attachment.
• Grease teeth of PTO shaft and flange.
• Open the attachment lock.
• Push the attachment into the machine connection flange.
• Close the attachment lock.
• Move the attachment or the machine until attachment lock engages.
Uncoupling
• Secure the machine against rolling away.
• Open the attachment lock and uncouple the attachment.
• Close the attachment lock.
Note
Problem when coupling "tooth-on-tooth"
Motor with recoil starter:
• Move PTO shaft lever to 700 rpm or 1000 rpm position.
• Switch ignition off.
• Engage.
• Slowly pull the recoil starter until the machine can be connected to the attachment.
• Move machine or attachment until bolt has engaged.
Motor without recoil starter:
• Disconnect machine from attachment.
• Start engine.
• Move PTO shaft lever to 700 rpm or 1000 rpm position.
• Tap "Clutch" switch.
• Turn off the engine.
• Connect attachment to machine - if this is not possible, repeat procedure.
• Move machine or attachment until bolt has engaged.
To make coupling easier, the handlebar can be rotated by 180° in order to provide a better
view.
Warning
The machine may suddenly trap the operator or third persons, cause them to fall over or
run them over.
• During coupling and uncoupling, ensure that nobody is in the danger zone.
• Attachment may only be connected to machine if engine is switched off.
• Coupling and uncoupling may cause hand injuries; wear safety gloves.
• After coupling attachments, check whether the attachment locking bolt is engaged and
the attachment is connected to the machine.
Bolt engaged Bolt not engaged