Attention before startup:
I
Attention
I
•
Before startup, all the handles shall be placed in center, the transmission
gear shall be in neutral position, and the starting switch shall be in off
position.
•
When just starting, do not step on the accelerator to the maximum
position to avoid the damage of engine parts.
•
Follow the right procedure to start the engine.
•
Adjust the operator's chair for a comfortable operation.
Steps to start the engine
*
Keep gear shifting handle in neutral position, hand brake lever in brake
condition.
*
Spin the starting switch to "START" position, and put the key back to
"ON" position after startup.
*
Preheat the engine for about 5 minutes. Step on the accelerator and
make it run in medium speed (28
6
-320rpm), warm up the unloaded
Forklift.
*
Check the running condition of the engine.
*
Check the sound of compression (or misfire).
*
Check the air exhaust condition.
*
Confirm all the indicator lights to go out.
*
After complete preheat of the engine, operate the multi-way valve
control lever for 2-3 times to check the working condition of the mast.
21
If nothing abnormal, and travel brake alarm light sends no alarm
indication, then the
Forklift can be started.
I Attention I
•
If it fails to start in 5 sseconds please turn back to "OFF" position. Start again
after an interval of 2 minutes.
•
In the event that the atmosphere temperature is lower than 41•F, the
preheating system may be used if startup is difficult. Turn the startup key to
"Preheat" position and keep it for 45~60 seconds before turning it to "Start"
position to start the engine. In case the engine still cannot be started up, return
the key to
"Preheat" position after an interval of 2 minutes and repeat the
above process.
•
The period of one startup shall not be over 5 ~ 1 0seconds.
•
The startup key should not be put in "Start" position for a long period
•
When the engine is running, the key should not be turned to the positions
of "Start" and "Off" .
Truck Operation
Inspection
&
preparation
•
After
the engine starts up, it
should
run
idle
for about 5
minutes.
Only after
the water temperature
rises up to
over
122
•
F
and the
engine oil temperature
up
to
104
°
F,
can the
Forklift
work with load.
•
When
the
engine is
running idle, check whether the readings on the
instruments
and meters (water thermometer, engine
oil pressure
gauge,
fuel
level
gauge)
meet
the
stipulated
requirements. If not,
stop
the engine
for inspection and troubleshooting.
•
Before driving
the
Forklift
, a
careful
inspection must be
made for
the
brake system (including
hand
brake
and
pedal brake). The
system
must
be sensitive and
reliable, or
it should be
adjusted.
Ranko R55 Forklift
Operator's Maintenance Manual
Operation &Use
Ranko R55 Forklift
Operator's Maintenance Manual
Operation &Use
