is heavy, please set fenders, signal, flag or warning light, and put other
necessary signals to make sure the passing vehicles can easily identify
the Forklift. Besides, do not make the Forklift, fenders and flags
obstacle to the traffic.
• When you stop the Forklift, unload the materials and lay flat the
forks on the ground, pull the control lever back to middle
position. If there is a locking device, use it to lock the control lever.
Shut down the engine and pull up the stop brake lever to brake
position. Use the key to lock all the equipments, then pull out the key.
When you get off the Forklift, face it and slowly go down. Make sure
three points of your body touch the hand rail and pedal. It is forbidden
to jump off the Forklift.
I
Dangerous
I
It is strictly forbidden to get up or get off the Forklift when it is
in motion.
20. Precautions when working in cold area
21. After operation, remove all the water, snow or mud attached to the
electric wires, wire connectors, switches or sensors. If you do not
remove them, the inside moisture will freeze and cause unexpected
failure to the Forklift.
22. Please fully preheat the Forklift before work. If you do not preheat the
Forklift before operate the control lever, the forklift will respond slowly
and unexpectedly break down.
23.
Operate all the control levers to cycle the hydraulic oil in the hydraulic
system (bring up the system pressure to the set point, then release it to
make the oil flow back to the hydraulic oil tank) and preheat it. This
way can guarantee the Forklift a good response and avoid any failure.
24.
If the electrolyte in the battery has frozen, do not charge the battery, or
49
use other power to start the engine. It can be very dangerous and
cause fire.
• When you charge the battery or use other power to start the engine,
dissolve the electrolyte before you start and check if any leakage.
21. Notes for operation after work
• Before leaving the seat, the operator must tilt forward the mast, lay
flat the forks on the ground, then put all the control levers back to
middle position, pull up stop brake at brake position in order to avoid
accident caused by movement of working device and forklift.
•
Shut down the engine and use the key to lock all the devices
attached with locks then keep keys with you.
22.
Fire protection
The fuel, lubrication oil and mixed liquor of coolants used in forklift
engine are inflammable material. It is very dangerous to have any
smoke or flame near the truck. Precautions:
•
K
eep the above-mentioned flammable liquid far away from flame.
•
Shut down the engine when refilling the fuel. Smoking or open fire is
strictly forbidden during refilling.
•
Tighten all the caps of the tanks where stores the above-
mentioned inflammable liquid.
•
Put the above-mentioned inflammable liquid into marked containers
and place them in safe place and store them classified. They are only
available for working staff.
•
Remove the inflammable material piled on the truck such as fuel,
lubrication oil or other loose material to make sure there is no oil
cloth or other inflammable material.
•
Do not weld or flame cut the pipe which contains flammable liquid.
Before welding for flaming cut, please clean up by non-flammable
liquid.
so
Ranko R55 Forklift
Operator's Maintenance Manual
Safety & Operation
Ranko R55 Forklift
Operator's Maintenance Manual
Safety & Operation