RAM 1500 2019, Руководство пользователя

Страница: 79 / 340

• The battery was discharged by an electrical
load left on when the vehicle was parked.
• The battery was used for an extended pe-
riod with the engine not running to supply
radio, lights, chargers, +12V portable ap-
pliances like vacuum cleaners, game con-
soles and similar devices.
What to do when an electrical load reduction
action message is present (“Battery Saver On”
or “Battery Saver Mode”)
During a trip:
• Reduce power to unnecessary loads if pos-
sible:
– Turn off redundant lights (interior or
exterior).
– Check what may be plugged in to power
o12V, 115V AC, USB ports.
– Check HVAC settings (blower, tempera-
ture).
– Check the audio settings (volume).
After a trip:
• Check if any aftermarket equipment was
installed (additional lights, upfitter electri-
cal accessories, audio systems, alarms) and
review specifications if any (load and Igni-
tion Off Draw currents).
• Evaluate the latest driving cycles (distance,
driving time and parking time).
• The vehicle should have service performed
if the message is still present during con-
secutive trips and the evaluation of the
vehicle and driving pattern did not help to
identify the cause.
WARNING LIGHTS AND MESSAGES
The warning/indicator lights will illuminate in
the instrument panel together with a dedi-
cated message and/or acoustic signal when
applicable. These indications are indicative
and precautionary and as such must not be
considered as exhaustive and/or alternative
to the information contained in the Owner’s
Manual, which you are advised to read care-
fully in all cases. Always refer to the informa-
tion in this chapter in the event of a failure
indication. All active telltales will display first
if applicable. The system check menu may
appear different based upon equipment op-
tions and current vehicle status. Some tell-
tales are optional and may not appear.
Red Warning Lights
— Seat Belt Reminder Warning Light
This light indicates when the driver or passen-
ger seat belt is unbuckled. When the ignition is
first placed in the ON/RUN or ACC/ON/RUN
position and if the driver’s seat belt is unbuck-
led, a chime will sound and the light will turn
on. When driving, if the driver or front passen-
ger seat belt remains unbuckled, the Seat Belt
Reminder Light will flash or remain on continu-
ously and a chime will sound.
Refer to “Occupant Restraint Systems” in
“Safety” for further information.
— Air Bag Warning Light
This light indicates a fault with the air bag,
and will turn on for four to eight seconds as a
bulb check when the ignition is placed in the
ON/RUN or ACC/ON/RUN position. This light
will illuminate with a single chime when a
fault with the air bag has been detected, it
will stay on until the fault is cleared. If the
light is either not on during startup, stays on,
or turns on while driving, have the system
inspected at an authorized dealer as soon as
possible.
77