RAM 1500 2019, Руководство пользователя

Страница: 179 / 340

• New vehicles from the dealership must
have at least 30 miles (48 km) accumu-
lated before the ParkSense Active Park As-
sist system is fully calibrated and performs
accurately. This is due to the system’s dy-
namic vehicle calibration to improve the
performance of the feature. The system will
also continuously perform the dynamic ve-
hicle calibration to account for differences
such as over or under inflated tires and new
tires.
Enabling And Disabling The ParkSense Active
Park Assist System
The ParkSense Active Park As-
sist system can be enabled and
disabled with the ParkSense Ac-
tive Park Assist switch, located
on the switch panel below the
Uconnect display.
NOTE:
If your vehicle is equipped with a 12–inch
Uconnect display, the ParkSense Active Park
Assist switch is located above the display.
To enable the ParkSense Active Park Assist
system, push the ParkSense Active Park As-
sist switch once (LED turns on).
To disable the ParkSense Active Park Assist
system, push the ParkSense Active Park As-
sist switch again (LED turns off).
Refer to your Owner's Manual for further
information.
LANESENSE
LaneSense Operation
The LaneSense system is operational at
speeds above 37 mph (60 km/h) and below
112 mph (180 km/h). It uses a forward
looking camera to detect lane markings and
measure vehicle position within the lane
boundaries.
When both lane markings are detected and
the driver unintentionally drifts out of the
lane while no turn signal has been applied OR
the driver departs the lane on the opposite
side of the applied turn signal (if the left turn
signal is applied and the vehicle departs to
the right), the LaneSense system provides a
haptic warning in the form of torque applied
to the steering wheel to prompt the driver to
remain within the lane boundaries. The Lane-
Sense system will also provide a visual warn-
ing through the instrument cluster display to
prompt the driver to remain within the lane
boundaries.
The driver may manually override the haptic
warning by applying torque into the steering
wheel at any time.
When only a single lane marking is detected
and the driver unintentionally drifts across
that lane marking (no turn signal applied),
the LaneSense system provides a visual warn-
ing through the instrument cluster display to
prompt the driver to remain within the lane.
When only a single lane marking is detected,
a haptic (torque) warning will not be pro-
vided.
NOTE:
When operating conditions have been met,
the LaneSense system will monitor if the
driver’s hands are on the steering wheel and
provides an audible and visual warning to the
driver when the driver’s hands are not de-
tected on the steering wheel. The system will
cancel if the driver does not return their
hands to the wheel.
177