RAM 1500 2019, Руководство пользователя

Страница: 177 / 340

NOTE:
Arc alerts from the enabled ParkSense sys-
tem, will interrupt the five second messages,
and the instrument cluster display will show
the vehicle graphic with the corresponding
arcs and "OFF" message.
The Front or Rear ParkSense switch LED will
be on when Front or Rear ParkSense is dis-
abled or requires service. The Front or Rear
ParkSense switch LED will be off when the
Front or Rear system is enabled. If the Front
or Rear ParkSense switch is pushed, and the
system requires service, the Front or Rear
ParkSense switch LED will blink momen-
tarily, and then the LED will be on.
Cleaning The ParkSense System
Clean the ParkSense sensors with water, car
wash soap and a soft cloth. Do not use rough
or hard cloths. Do not scratch or poke the
sensors. Otherwise, you could damage the
sensors.
ParkSense System Usage
Precautions
NOTE:
• Ensure that the front and rear bumper are free
of snow, ice, mud, dirt and debris to keep the
ParkSense system operating properly.
• Jackhammers, large trucks, and other vi-
brations could affect the performance of
ParkSense.
• When you turn Front or Rear ParkSense off,
the instrument cluster display will show a
vehicle graphic of the Front or Rear
ParkSense on/off state for two seconds. Fur-
thermore, once you turn Front or Rear
ParkSense off, it remains off until you turn it
on again, even if you cycle the ignition key.
• When you move the gear selector to the
REVERSE position and Front or Rear
ParkSense is turned off, the instrument
cluster display will show a vehicle graphic
with "OFF" in the corresponding side. This
vehicle graphic will be displayed for as long
as the vehicle is in REVERSE.
• ParkSense, when on, will reduce the vol-
ume of the radio when it is sounding a tone.
• Clean the ParkSense sensors regularly, tak-
ing care not to scratch or damage them. The
sensors must not be covered with ice, snow,
slush, mud, dirt or debris. Failure to do so
can result in the system not working prop-
erly. The ParkSense system might not de-
tect an obstacle behind or in front of the
fascia/bumper, or it could provide a false
indication that an obstacle is behind or in
front of the fascia/bumper.
• Use the ParkSense switch to turn the
ParkSense system off if obstacles such as
bicycle carriers, trailer hitches, etc. are
placed within 12 inches (30 cm) from the
rear fascia/bumper. Failure to do so can
result in the system misinterpreting a close
obstacle as a sensor problem, causing the
“PARKSENSE
UNAVAILABLE SERVICE
REQUIRED” message to be appear in the
instrument cluster display.
• On vehicles equipped with a tailgate,
ParkSense should be disabled when the
tailgate is in the lowered or open position. A
lowered tailgate could provide a false indi-
cation that an obstacle is behind the
vehicle.
175