RAM 1500 2019, Руководство пользователя

Страница: 102 / 340

pressure is below the low-pressure warning
limit in any of the four active road tires. The
vehicle may need to be driven for up to
20 minutes above 15 mph (24 km/h) in
order
for the TPMS to receive this
information.
Tire Fill Alert
This feature notifies the user when the plac-
ard tire pressure is attained while inflating or
deflating the tire.
The customer may choose to disable or en-
able the Tire Fill Alert feature through use of
the customer settings in the radio.
NOTE:
• Only one tire can be filled at a time when
using the Tire Fill Alert system.
• The Tire Fill Alert feature cannot be entered
if an existing TPM system fault is set to
“active” or if the system is in deactivation
mode (if equipped).
The system will be activated when there is
over 1.5 psi (10 kPa) of change in tire pres-
sure. The ignition must be in the RUN mode,
with the transmission in PARK (P).
NOTE:
It is not required to have the engine running
to enter Tire Fill Alert mode.
The hazard lamps will come on to confirm the
vehicle is in Tire Fill Alert mode.
When Tire Fill Alert Mode is entered, the tire
pressure display screen will be displayed in
the instrument cluster.
Operation:
• The horn will chirp to let the user know
when to stop filling the tire, when it reaches
recommended pressure.
• The horn will chirp three times if the tire is
over filled and will continue to chirp every
five seconds if the user continues to inflate
the tire.
• The horn will chirp once again when
enough air is let out to reach proper infla-
tion level.
• The horn will also chirp three times if the
tire is then under-inflated and will continue
to chirp every five seconds if the user con-
tinues to deflate the tire.
General Information
This device complies with Part 15 of the FCC
rules and RSS 210 of Industry Canada. Op-
eration is subject to the following conditions:
1. This device may not cause harmful
interference.
2. This device must accept any interference
received, including interference that may
cause undesired operation.
NOTE:
Changes or modifications not expressly ap-
proved by the party responsible for compli-
ance could void the user’s authority to oper-
ate the equipment.
SAFETY
100