RAM 1500 2019, Руководство пользователя

Страница: 215 / 340

Rear Jacking Location
Operate the jack using the extension with
jack hook and the lug wrench. The exten-
sion tubes may be used but is not re-
quired.
When changing a rear wheel, assemble
the extension with jack hook to the jack
and connect the extension tubes.
Access
the rear jacking location from behind the
rear tire.
Place the jack under the Jack
Lift Feature located on the rear axle lower
control arm bracket. Then locate the slot
in the jack lift plate onto the rear axle
Jack Lift Feature with the extension with
jack hook extending to the rear.
Connect the long extensions and lug
wrench.
CAUTION!
Before raising the wheel off the ground,
make sure that the jack will not damage
surrounding truck parts and adjust the
jack position as required.
4. By rotating the lug wrench clockwise,
raise the vehicle until the wheel just
clears the surface.
WARNING!
Raising the vehicle higher than necessary
can make the vehicle less stable. It could
slip off the jack and hurt someone near it.
Raise the vehicle only enough to remove
the tire.
5. Remove the lug nuts and pull the wheel
off. Install the spare wheel and lug nuts
with the cone shaped end of the lug nuts
toward the wheel. Hand tighten the lug
nuts with vehicle lifted. To avoid the risk
of forcing the vehicle off the jack, do not
fully tighten the lug nuts until the vehicle
has been lowered.
6. Lower vehicle to ground, finish tightening
the lug nuts. Push down on the wrench
while at the end of the handle for in-
creased leverage. Tighten the lug nuts in a
star pattern until each nut has been tight-
ened twice.
Rear Jacking Lift Feature
213