RAM 1500 2019, Руководство пользователя

Страница: 59 / 340

Reprogramming A Single HomeLink Button
(Non-Rolling Code)
To reprogram a channel that has been previ-
ously trained, follow these steps:
1. Cycle the ignition to the ON/RUN
position.
2. Push and hold the desired HomeLink but-
ton until the indicator light begins to flash
after 20 seconds.
Do not release the button.
3. Without releasing the button proceed with
“Programming A Non-Rolling Code” step
2 and follow all remaining steps.
Canadian/Gate Operator
Programming
For programming transmitters in Canada/
United States that require the transmitter
signals to “time-out” after several seconds of
transmission.
Canadian radio frequency laws require trans-
mitter signals to time-out (or quit) after sev-
eral seconds of transmission – which may not
be long enough for HomeLink to pick up the
signal during programming. Similar to this
Canadian law, some U.S. gate operators are
designed to time-out in the same manner.
It may be helpful to unplug the device during
the cycling process to prevent possible over-
heating of the garage door or gate motor.
1. Turn the ignition switch to the ON/RUN
position.
NOTE:
For vehicle’s equipped with Keyless Enter-
N-Go, place the ignition in the RUN posi-
tion with the Engine ON. For vehicle’s
equipped with Keyless Enter-N-Go, place
the ignition in the RUN position with the
Engine ON. Make sure while programming
HomeLink with the engine ON that your
vehicle is outside of your garage, or that
the garage door remains open at all times.
2. Place the hand-held transmitter 1 to
3 inches (3 to 8 cm) away from the
HomeLink button you wish to program.
3. Push and hold the HomeLink button while
you push and release (“cycle”), your
hand-held transmitter every two seconds.
4. Continue to hold both buttons until the
instrument cluster display changes from
“CHANNEL # TRAINING” to “CHANNEL
# TRAINED,” then release both buttons.
NOTE:
• It may take up to 30 seconds or longer
in some cases for the channel to train.
• If the instrument cluster display shows
“DID NOT TRAIN”, repeat from Step 2.
5. Push and hold the programmed
HomeLink button. The instrument cluster
display will display “CHANNEL # TRANS-
MIT.” If the device is plugged in and
activates, programming is complete.
If you unplugged the garage door opener/
device for programming, plug it back in at
this time.
57