Raider 40 hp, Руководство по обслуживанию, Страница: 169 / 193

9-4
4. Tilt the outboard to full tilt position into the RIB; and turn so the drain
valves are on the lowest side.
5. Allow the water from the front valve drain out.
6. Pull starter handle slowly until starter engages. Continue pulling with
firm pressure to force water out of the engine as water is ejected with
slow, light pulls from the pull starter. Continue until no more water is
ejected.
7. Close the three valve ports in a clockwise rotation.
8. Two pulses on the rubber fuel ball inject new fuel into the Raider.
CAUTION
CAUTION CAUTION CAUTION
To avoid outboard falling during de-water procedure, tilt/run lever MUST
remain in the TILT position. When the engine begins to turn freely, pull an
additional four times. This will help drain water that might be trapped in the
cylinders.
9. Tilt outboard to the normal running position.
10. Replace emergency stop clip and lanyard.
11. Squeeze primer bulb several times until definite resistance is felt.
12. With twist grip in the ⑮-throttle position, pull starter handle to start engine.
13. After engine has run at IDLE speed for 30-60 seconds, turn drain valves to
the RUN position.
IMPORTANT:
IMPORTANT: IMPORTANT: IMPORTANT:
DO NOT run the outboard with the drain valves in the DRAIN position more
DO NOT run the outboard with the drain valves in the DRAIN position more DO NOT run the outboard with the drain valves in the DRAIN position more DO NOT run the outboard with the drain valves in the DRAIN position more
than 3 minutes. Engine damage can result.
than 3 minutes. Engine damage can result. than 3 minutes. Engine damage can result. than 3 minutes. Engine damage can result.
Continue to run under normal operating conditions (RIB on plane) for at least
30 minutes (2500 RPM or above).
IMPORTANT:
IMPORTANT: IMPORTANT: IMPORTANT:
You MUST run the outboard after the dewater procedure to dry out internal
You MUST run the outboard after the dewater procedure to dry out internal You MUST run the outboard after the dewater procedure to dry out internal You MUST run the outboard after the dewater procedure to dry out internal
moisture.
moisture. moisture. moisture.
The operator does not need to remove the cowling to dewater the Raider. The
Raider should start within two/three pulls after the dewatering valves are
closed.