
7-6
l)
Freezing Weather
Freezing Weather
Freezing Weather
Freezing Weather: : : : To avoid engine damage, keep the gear case
submerged in the water at all times. Before operating in freezing
temperatures, check gear case lubricant. If leakage is found, gear case
seals will need service. Refer to Section 8, Gear case.
When removing engine from water, keep the engine in an upright position
until the cooling system is completely drained.
o
Water that leaks into gear case or is left in the cooling system can
freeze when the engine is removed from the water. This can cause
serious damage.
4..
4..
4..
4..Overheating
Overheating
Overheating
Overheating
o
DO NOT
DO NOT
DO NOT
DO NOT operate engine out of water even momentarily.
o
The engine’s Water Temperature sensor is NOT a warning device it
has been silenced for mission effectiveness.
o
The RAIDER does not have the normal overheat warning sounding
device.
o
The RAIDER will not initiate a warning to prevent powerhead damage.
o
If you suspect the engine is overheating or has overheated, STOP the
engine only when it is safe
only when it is safe
only when it is safe
only when it is safe.
o
When operating the engine, the water intakes must be completely
submerged. Make sure the water intake screens are not installed
Make sure the water intake screens are not installed
Make sure the water intake screens are not installed
Make sure the water intake screens are not installed
upside down
upside down
upside down
upside down (ramps must be forward). If upside down, the engine will
overheat. Observe proper transom height and engine trim angle.
o
When engine is running, the water pump must be discharging a
steady stream of water. Check often, particularly when operating in
weeds, mud, or debris laden water, or at an extreme engine angle.
o
IF
IF
IF
IF the water pump stops or becomes intermittent, reduce engine
speed to an idle when it is safe. Shift engine into REVERSE and
operate at a slow speed for about 10 seconds. This might clear debris
blocking the water intake screens.
o
IF
IF
IF
IF the water pump indicator is still not discharging
not discharging
not discharging
not discharging a steady stream of
water, SHUT OFF
SHUT OFF
SHUT OFF
SHUT OFF the engine when it is safe. Clean the water intake
screens and water pump indicator. Restart the engine and run at idle.
o
IF
IF
IF
IF the water pump still does not discharge a steady stream of water,
SHUT OFF
SHUT OFF
SHUT OFF
SHUT OFF the engine when it is safe. DO NOT
DO NOT
DO NOT
DO NOT attempt to operate
engine. Refer to Section 8, Gear case, Water Pump Assembly.
Section 8, Gear case, Water Pump Assembly.
Section 8, Gear case, Water Pump Assembly.
Section 8, Gear case, Water Pump Assembly.
5.
5.
5.
5. Emergency Starting
Emergency Starting
Emergency Starting
Emergency Starting
o
Make sure the shift lever is at NEUTRAL to prevent sudden boat
movement when the engine starts.
Содержание 40 hp
