Raider 40 hp, Руководство по обслуживанию, Страница: 146 / 193

6-8
Gear Gear Gear Gear Backlash Backlash Backlash Backlash
PositioningBevelGear8:ShimmingGauge PositioningBevelGear8:ShimmingGauge PositioningBevelGear8:ShimmingGauge PositioningBevelGear8:ShimmingGauge
Positioning of bevel gear B must be performed prior to the back lash
measurement.
Special Tool Shimming gauge 387-72250-0
Thickness gauge 353-72251-0
Checking
Checking Checking
Checking
1. Instal lower pump case to fix driveshaft.
1. Instal lower pump case to fix driveshaft. 1. Instal lower pump case to fix driveshaft. 1. Instal lower pump case to fix driveshaft.
Note: use bolt and plain washers.
Tightening torque
11-15N-m(1.1-1.5kg-m)[8-11lb-ft]
2. Install bevel gear B
2. Install bevel gear B 2. Install bevel gear B
2. Install bevel gear B .
Tightening torque
40-58N-m(4-6kg-m)[29-44lb-ft]
3. Insert shimming gauge
3. Insert shimming gauge 3. Insert shimming gauge
3. Insert shimming gauge ....
Note:*Taper
(T)
must be contacted to bearing outer surface firmly.
*Opening slit of shimming gauge at (N) must be at the position12
o'clock.
4. Measure the gap between (M) position of gauge and bevel gear B with 4. Measure the gap between (M) position of gauge and bevel gear B with 4. Measure the gap between (M) position of gauge and bevel gear B with 4. Measure the gap between (M) position of gauge and bevel gear B with
thickness
thickness thickness thickness gauge gauge gauge gauge ....
Note:When measuring,drive shaft must be pulled up as shown as a narrow
mark completely so as not have any play.
Gap
0.6-0.64mm(0.0236-0.0252in)
5. If
5. If 5. If
5. If
the gap is not in the specified range ,adjust the gap with the shim. the gap is not in the specified range ,adjust the gap with the shim. the gap is not in the specified range ,adjust the gap with the shim. the gap is not in the specified range ,adjust the gap with the shim.
Shim Location
0.1mm(0,00394in)
0.15mm(0.00591in)
0.3mm(0.01181in)
Between Lower pump case and
bearing.