Configuring Ports on the SCOPIA TIP Gateway
This section provides instructions of how to configure the following ports and port ranges on
the SCOPIA TIP Gateway:
•
Limiting TCP Port Range for H.245 on the SCOPIA TIP Gateway ...................... page 25
•
Configuring RTP/RTCP/SRTP Ports on the SCOPIA TIP Gateway ...................... page 26
•
Configuring UDP Port for RAS on the SCOPIA TIP Gateway ............................ page 27
•
Configuring TCP Port for Q.931 on the SCOPIA TIP Gateway .......................... page 27
Limiting TCP Port Range for H.245 on the SCOPIA TIP Gateway
The SCOPIA TIP Gateway designate ports 1024-1174 for H.245 (signaling). H.245 is a control
protocol used for multimedia communications that enables transferring information about the
device capabilities, as well as opening/closing the logical channels that carry media streams.
To provide additional security for your firewall, you can limit this range.
Procedure
Step 1
Log in to the SCOPIA Management administrator portal.
Step 2
Select Devices > Devices by Type > Gateways.
Step 3
Select the relevant gateway from the Gateways list.
Step 4
Select the Configure tab (see
).
Figure 5-4
Configuring a gateway from SCOPIA Management
RADVISION | Deployment Guide for SCOPIA TIP Gateway Version 8.0
Configuring your SCOPIA Solution for Interoperability with Cisco Telepresence | 25
