Procedure
Step 1
From inside the front-facing rack post, mark the location of the device-fixing cage nut
measured at 0.75 inches (2 cm) above the shelf. See
.
Figure 4-5
Marking the location of the device-fixing cage nut on the rack
Step 2
Repeat this procedure for the other front-facing post.
Removing the Cage Nut Screws
The cage nuts are supplied with pre-mounted screws. Remove the screws and put them aside
for later. See
.
Figure 4-6
Removing the cage nut screw
Mounting the Device-fixing Cage Nuts
After you have marked the location of these cage nuts on the front-facing posts, you can
mount them into the rack. Insert each cage nut on each of the posts where you have placed
marks on the rack.
RADVISION | Deployment Guide for SCOPIA TIP Gateway Version 8.0
Setting up the SCOPIA TIP Gateway | 17
