Figure 5-12
Cisco CTS Configuration screen
Step 5
Configure your telepresence endpoint as described in this table.
Table 5-5
Configuring telepresence endpoints
Field Name
Description
Name
Enter a name used to identify the endpoint. This is the name
displayed in the list of endpoints.
Description
Enter any description text that you may have for this endpoint.
Triple
Select this field if you are adding a 3-segment CTS-3000 Series
endpoint to the deployment.
Protocol
For Cisco telepresence, this field is pre-configured to IP (SIP)
since the CTS endpoints are using the SIP protocol.
URI
Enter the CTS phone number that is dialed when calling the
Telepresence System from the SCOPIA Elite MCU.
Location
Select the location of the telepresence system, from the list.
Visible in the directory
of other endpoints
Select to display the telepresence system in the corporate
address book.
The telepresence endpoint is represented in the address book as a
single endpoint.
Step 6
Select OK.
Once configured, the Endpoints tab displays a small icon
near the endpoint name,
indicating that the endpoint is a telepresence system as well as dialing info numbers with
relevant prefixes.
Step 7
Repeat the above steps for each CTS in the deployment.
Step 8
You can modify these settings at any time by selecting the device name link in the All
endpoints list.
RADVISION | Deployment Guide for SCOPIA TIP Gateway Version 8.0
Configuring your SCOPIA Solution for Interoperability with Cisco Telepresence | 39