Step 7
Allow SCOPIA Management to access the SCOPIA Gateway:
a.
Select the Access tab.
b.
Enter the login name and password of the SCOPIA Gateway. The default username is
admin and the default password is password.
c.
Select Apply.
Configuring Cisco Telepresence in SCOPIA Management
For general information about telepresence systems, see the Administrator Guide for SCOPIA
Management.
For information on the telepresence deployment, see
“Planning your Topology for the TIP
These procedures describe the planning and configuration of telepresence in SCOPIA
Management.
•
Adding the CUCM to SCOPIA Management ............................................... page 33
•
Adding the CTMS to SCOPIA Management ............................................... page 34
•
Adding Cisco Telepresence Systems (CTS) in SCOPIA Management .................. page 38
Adding the CUCM to SCOPIA Management
To enable SCOPIA Management to operate with Cisco telepresence, configure SCOPIA
Management with the CUCM which is the call manager to which Cisco telepresence endpoints
are registered. For the SCOPIA Solution, the CUCM acts as a proxy SIP server.
You can view the connection status between SCOPIA Management and the CUCM (SIP server)
by navigating to Devices > SIP Servers.
Procedure
Step 1
Access the SCOPIA Management administrator portal.
Step 2
Select the Devices tab.
Step 3
Select SIP Servers in the sidebar.
Step 4
Configure the SIP server settings in the Basics section, as described in this table.
RADVISION | Deployment Guide for SCOPIA TIP Gateway Version 8.0
Configuring your SCOPIA Solution for Interoperability with Cisco Telepresence | 33
