RADVision Scopia TIP Gateway, Руководство по развертыванию

Страница: 32 / 77

Step 9
Set the audio base port by doing the following:
a. Enter the advcmdmapsetval command in the Command field.
b. Enter the mf.UdpBasePort parameter in the Parameter field.
c. Enter the port value in the Value field.
d. Select Save.
e. Enter the mapconfigcompleted command in the Command field.
f. Enter 1 in the Value field.
g. Select Save.
Step 10
Select Close.
Configuring UDP Port for RAS on the SCOPIA TIP Gateway
The SCOPIA TIP Gateway designates port 1719 for RAS, the protocol for signaling messages.
You can configure a different port for RAS (if, for example, port 1719 is busy).
Procedure
Step 1
Log in to the SCOPIA Management administrator portal.
Step 2
Select Devices.
Step 3
Select Gateways in the sidebar menu.
Step 4
Select the relevant gateway from the Gateways list.
Step 5
Select the Configure tab (see Figure 5-4 on page 25 ).
Step 6
Select Advanced Parameters Settings. The Advanced Parameters dialog box appears (see
Figure 5-4 on page 25 ).
a. Select h323rasport from the Command ID list.
b. Enter the port value in the Value field.
c. Select Save.
d. Select Close.
Configuring TCP Port for Q.931 on the SCOPIA TIP Gateway
The SCOPIA TIP Gateway designates port 1720 for Q.931. Q.931 is a telephony protocol used
for establishing and terminating the connections in H.323 calls. You can configure a different
port for Q.931 (if, for example, port 1720 is busy).
Procedure
Step 1
Log in to the SCOPIA Management administrator portal.
Step 2
Select Devices.
Step 3
Select Gateways in the sidebar menu.
RADVISION | Deployment Guide for SCOPIA TIP Gateway Version 8.0 Configuring your SCOPIA Solution for Interoperability with Cisco Telepresence | 27