RADVision Scopia TIP Gateway, Руководство по развертыванию

Страница: 31 / 77

Step 5
Select Advanced Parameters Settings. The Advanced Parameters dialog box appears (see
Figure 5-4 on page 25 ).
Step 6
To set the base port for the H.245 control channel protocol, do the following:
a. Clear the values before proceeding to the next step.
b. Enter h245baseport in the Command ID field.
c. Enter the port value in the Value field.
d. Select Save.
e. Select Close
Step 7
To set the port range for H.245, do the following:
a. Clear the values before proceeding to the next step.
b. Enter h245portrange in the Command ID field.
c. Enter the port value in the Value field.
d. Select Save.
e. Select Close
Configuring RTP/RTCP/SRTP Ports on the SCOPIA TIP Gateway
The SCOPIA TIP Gateway designates ports 16384-17584 for UDP audio media, and 12000-13200
for UDP video media.
Procedure
Step 1
Log in to the SCOPIA Management administrator portal.
Step 2
Select Devices.
Step 3
Select Gateways in the sidebar menu.
Step 4
Select the relevant gateway from the Gateways list.
Step 5
Select the Configure tab (see Figure 5-4 on page 25 ).
Step 6
Select Advanced Parameters Settings. The Advanced Parameters dialog box appears (see
Figure 5-4 on page 25 ).
Step 7
Set the UDP video base port by doing the following:
a. Enter the advcmdmvpsetval command in the Command field.
b. Enter the mf.BasePort parameter in the Parameter field to set the UDP video base port.
c. Enter the port value in the Value field.
d. Select Save.
Step 8
Complete the video base port configuration as follows:
a. Enter the mvpconfigcompletedcommand command in the Command field.
b. Enter 1 in the Value field.
c. Select Save.
d. Clear the value in the Parameter field before proceeding to the next step.
RADVISION | Deployment Guide for SCOPIA TIP Gateway Version 8.0 Configuring your SCOPIA Solution for Interoperability with Cisco Telepresence | 26