5.2.5
Removing the Optional FastPass Elevator Expansion Module
The following instructions will describe removing a FastPass elevator expansion
module between two libraries, however additional libraries can be disconnected by
repeating the procedure.
1.
If the libraries are powered up, press the Park Rear button on the Park Handler
section of the libraries Home Page to move the handler to the rear of the library.
See Figure 5-13.
2.
Remove power from both of the libraries by first pressing the power switch off
and then removing the power cord.
3.
Remove the black elevator module cable that is attached between the libraries.
4.
Using a Number 2 Phillips screwdriver to remove the eight screws that secure
both the upper and lower elevator expansion units.
5.
Carefully slide the
lower
elevator expansion unit out from the lower library.
CAUTION
It is important to visually confirm that the elevator mechanism is in its upper
position before attempting to remove the upper elevator module from the library.
Damage to the module can occur if the elevator is in its lower position when it is
being removed.
6.
Look through the opening where the lower elevator expansion unit was removed
and confirm that the elevator mechanism is in its upper position as shown in
Figure 5-28. If it is not in this position, reach into the library and push it
upwards until it is completely in the upper position.
5-24
Installation
511000 Rev. F
