Remove these 4 Screws
User Interface
Panel Assembly
Figure 5-15 Screws shown securing the face of the User Interface Panel Assembly
11.
Once all four screws are removed carefully pull the panel off from the user
interface assembly and set aside.
12.
Now reaching into the RLS through the opening below the touch screen, engage
the two captive screw fasteners and turn them counter clockwise until they are
fully loosened.
13.
Once both screws from the Storage Matrix Assembly Blank are loosened,
carefully pull it off the RLS and set it aside.
14.
Using a Number 2 Phillips screwdriver loosen the two screws (one on each side)
that secure each library to the front rack posts.
15.
On the rear of the two libraries two panels need to be removed so the FastPass
elevator expansion modules can be installed.
16.
As shown in Figure 5-16 use a Number 2 Phillips screwdriver to remove the four
screws securing the panel to the lower library. Next use a T15 Torx driver to
remove the four screws securing the panel to the upper library. If the upper
library contains Phillips screws, simple remove them with the Number 2 Phillips
screwdriver.
511000 Rev. F
Installation 5-15
