QuadroM32x Manual I: Installation Guide
Step 2: Configuring the Quadro
Dialing Delay Timeout text field is used to define a timeout (in a range from 0 to 2000 mil-
liseconds) before injecting dialed digits. Timeout specially refers to R2 DTMF signaling.
Incoming DNIS Size text field indicates the number of received digits (in a range from 0 to
255) required to establish a call. When this field has a “0” value, the system uses either
timeout defined in the Incoming digits timeout field or the End of Address messages to
establish a call. Independent on the value in this field, the message End of Address al-
ways causes the call establishment.
Usused A:B:C:D text fields require to configure unused C and D bits of E1/T1 CAS signal-
ing (A and B bits are predefined). Fields may have either 0 or 1 values.
Invert A:B:C:D text fields are used to invert the ABCD status bits in time-slot 16 before TX
and after RX. If bit is set to 1, the router inverts it before transmission and after the receipt.
End of DNIS (I-15) checkbox is used to enable End of DNIS service.
Collect Call checkbox is only available when Brazil is selected in the Country drop down
list on the previous page of the wizard and when the PBX attached to the Quadro supports
this feature. When this checkbox is selected and in case of incoming calls, always the
called destination will pay for the call. Option is particularly applicable when calling from the
mobile phone. Checkbox should be selected when the appropriate feature is enabled on
the PBX.
Group B Support manipulation radio button group is present only when R2 signaling se-
lected from Signaling Type drop down list on the previous page is different from R2 DTMF
and is used to enable/disable the Group B Support. The Group B Support manipulation
radio button group offers following selections:
•
Enable – this selection enables Group B Support both for answer and busy rec-
ognitions of transmit and receive signals. This selection requires you to define
transmit and receive signals. The Transmit Answer Signal and Transmit Busy
Signal parameters are defined from the drop down lists on this page. When trans-
mit signals are selected, press Next on this page to access the R2 Receive Signal
Settings page where Receive Answer Signal and Receive Busy Signal should
be defined. Use the checkboxes to select the Receive Answer Signal and Re-
ceive Busy Signal values. Multiple values are allowed for each signal.
Please Note:
Warning appears if you have selected the same signal type both for
receive answer and receive busy recognitions.
QuadroM32x; (SW Version 5.2.x)
41
Содержание QuadroM32x
Страница 1: ......
