QuadroM QuadroM32x, Руководство по установке

Страница: 38 / 55

QuadroM32x Manual I: Installation Guide Step 2: Configuring the Quadro
•
On call acceptance – with this selection, voice will be established after call is
being accepted.
•
On channel selection - with this selection, call will be accepted during channel
selection. This selection is not allowed for R2 signaling.
•
On call ringing - with this selection, voice will be established after call is being
ringing. Selection enables Generate Progress Tone to IP checkbox which is
used to enable the progress tone generation upon voice establishment.
Press Next to move to the second page of the CAS Signaling Wizard:
Fig. I-34: CAS Signaling Wizard - Page 2
CAS Signaling Wizard - Page 2 appears if the Signaling Type on the previous page is
set to any of the E&M types or to R2 DTMF. From this page of the CAS Signaling Wizard,
DID (Direct Inward Dialing) Service might be enabled on the timeslot(s).
In User mode, the Quadro cannot route incoming calls from the E1/T1 trunk to extensions if
the timeslot in the trunk does not have DID service enabled. Incoming call routing takes
place according to the received caller ID. If the DID service is enabled on some timeslot(s),
an incoming call on these timeslots may be routed to the specified extension, the Atten-
dant, or the routing client (depending on the configuration).
Please Note: The timeslot with DID service enabled cannot be used for outgoing calls.
In Network mode DID service does not limit the Quadro functionality but a timeslot with
enabled DID service cannot be used for incoming calls.
Please Note: The CO/private PBX must support the DID service, if it is to be configured on
the QuadroM32x.
Press Next to move to the third page of the CAS Signaling Wizard:
Fig. I-35: CAS Signaling Wizard - Page 3
QuadroM32x; (SW Version 5.2.x)
38