QuadroM32x Manual I: Installation Guide
Step 2: Configuring the Quadro
(see Username and Password). You may use either these values or specify new ones.
The Password field is checked against its strength and you may see how strong is your in-
serted password right below that field. To achieve the well protected strong password
minimum 8 characters of letters in upper and lower case, symbols and numbers should be
used. If you are unable to define a strong password, press Choose Generated Password
to use one of system defined strong passwords.
The Use Session Timer enables the SIP session timer for the corresponding IP line. This
checkbox enables advanced mechanisms for connection activity checking. This option al-
lows both user agents and proxies to determine if the SIP session is still active.
The Enable Hot Desking Capability checkbox is used to enable the Hot Desking feature
on the corresponding IP line (for details, see Manual II – Administrator’s Guide).
The Hot Desking Automatic Logout section is used to configure Hot Desking functionality
expiration on the corresponding IP line. This may be useful when someone who logged in
to the public phone with the extension attached to this line forgot to log out after using it.
With this option enabled, once the expiration time arrives, the extension will automatically
log out from the public phone.
The following options are available:
•
Never – the extension will never expire and will remain logged in to the public
phone.
•
After the defined period of time – requires the period after which the extension
will automatically log out from the public phone.
•
At the certain moment – requires the moment (hour and minute) when the ex-
tension will automatically log out from the public phone.
Press Save to apply the settings for the IP line.
Reset the SIP Phone. After restart, the appropriate configuration will be automatically
downloaded from the Quadro to the SIP Phone.
Please Note:
For automatic configuration, some SIP phones may require additional actions
to follow the restart. For example, by default the IP Dialog SIP Tone II is in a non-auto-
provisioning mode, so it should be manually enabled on the phone. Refer to the user’s
manual of the corresponding SIP phone for instructions on performing a factory reset or re-
boot on any of the supported phones, what additional configurations are required for a spe-
cific SIP phone, and how to manipulate with the GUI.
You may also find the detailed installation instructions of the Epygi’s supported and tested
IP Phones in the “Configuring Epygi Supported IP Phones” and “Configuring Epygi
Tested IP Phones” documents published on the Epygi’s Web portal.
To make sure the line configuration works properly, do the following:
•
Go to System – Status - IP Line Registration Status to see if IP Line registra-
tion is successful.
•
Dial *74 to get the line information.
•
Make outgoing and accept incoming calls.
QuadroM32x; (SW Version 5.2.x)
28
Содержание QuadroM32x
Страница 1: ......
