EZ2 Connect MDx User Manual 05/2022
42
3.3.4
Camera
Figure 19. Camera module.
The EZ2 Connect MDx has a built-in camera that is used for load checks and reading bar codes
from cartridges.
Load checks are done before a protocol run starts. The camera checks if labware has been loaded
in the correct positions. The results of the load check are shown on the screen. For more information
on the load check, refer to the Load check section (see page 118).
The camera also reads the cartridge 2D bar codes. Information that is collected from the 2D bar
codes is included in run reports.
3.3.5
UV LED lamp
The EZ2 is equipped with a UV LED light to support decontamination. During the maintenance
decontamination procedure, the UV LED moves over the worktable.
Note
: The hood must be closed before starting a maintenance procedure and is automatically locked
during the procedure.
