Q CELLS Q.VOLT-G2 HYB-4.6kW.1.1, Руководство по установке

Страница: 57 / 118

3. Connect a LAN cable to laptop and ESS.
4. Turn on AC circuit breaker at grid side, turn PV switch to ON position.
5. On the laptop, open an internet browser, enter http://17.91.23.196:8000 in address bar to access
SIM page. If you do not know the password, please contact your supplier.
Refer to Chapter 13 for contact information.
6. Input settings following steps after 7.3
7. Turn PV switch to OFF position, Turn off AC circuit breaker at grid side.
8. Remove short bars from board.
9. Disconnect LAN cable from laptop, connect to internet.
10. Turn on AC circuit breaker at grid side, turn PV switch to ON positon
7.3.3.2 Network connection
1. Turn on AC circuit breaker at grid side, turn PV switch to ON position
2. Connect LAN cable to ESS and existing internet network (”network”).
3. On the ESS LCD screen, check IP address.
4. On the laptop, open an internet browser, enter http://IP_Address:8000 in address bar to access
SIM page (For instance, if IP address is 192.168.12.34, than enter http://192.168.12.34:8000).
If you do not know the password, please contact your supplier. Refer to Chapter 13 for contact
information.
5. Input settings following steps after 7.3.
Entering Initial Installation Information
I 50
[ Figure 7-3 : Initial Setup Page ]