58
Push
IMPACT DRILL
THE NUMBERS IN THE FOLLOWING TEXT
CORRESPOND WITH THE PICTURES AT PAGE 2
TECHNICAL SPECIFICATIONS
PRODUCT INFORMATION
Fig.A
1 Left/right switch
2 On/off switch with speed control
3 Switch lock
4 Side handle
5 Chuck
6 Drill dept limiter
7 Switch for normal and percussion drilling
PACKAGE CONTENTS
The package contains:
1 Impact
drill
3 Drills (Concrete 4, 6 and 8 mm)
1 Depth
gauge
1 Side handle
1 Instruction
manual
1 Warranty
card
Check the machine, loose parts and accessories for
transport damage.
SAFETY INSTRUCTIONS
The following symbols are used throughout this manual:
Denotes risk of personal injury, loss of life or
damage to the tool in case of non-observance of
the instructions in this manual.
Denotes risk of electric shock.
Carefully read this manual before using the machine.
Make sure that you know how the machine functions and
how to operate it. Maintain the machine in accordance
with the instructions to make sure it functions properly.
ELECTRICAL SAFETY
When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions.
Keep these instructions in a safe place!
Always check that the power supply corresponds to
the voltage on the rating plate.
Your machine is double insulated in
accordance with EN 50144; therefore no
earthwire is required.
Replacing cables or plugs
Immediately throw away old cables or plugs when they
have been replaced by new ones. It is dangerous to insert
the plug of a loose cable in the wall outlet.
Using extension cables
Only use an approved extension cable suitable for the
power input of the machine. The minimum conductor
size is 1.5 mm
2
. When using a cable reel always unwind
the reel completely.
BEFORE OPERATING THE MACHINE:
•
Check the following:
Do the voltage of the machine correspond with the
mains voltage
Are the mains lead and the mains plug in a good
condition.
•
Do not use extension cables which are too long. Use
extension cables with a core diameter of 1.5 mm
2
minimal and only when the cable is rolled out
completely.
•
In case of a blockage, switch of the machine
immediately.
•
Always compare the maximum rotation speed of
accesoires with the maximum speed of the
percussion drill.
•
Pull the mainsplug from the socket before you
change a drill or accessory.
WHEN OPERATING THE MACHINE:
•
Check if the switch is placed in the ‘OFF’-position
before you connect the machine to mains.
•
Keep the mains cable away from moving parts of the
machine.
Voltage
| 230 V
Frequency
| 50 Hz
Power input
| 500 W
No load speed/min
| 0-2500
Impact rate/min
| 0-40000
Max. drill diameter (Wood)
| 25 mm
Max. drill diameter (Concrete) | 13 mm
Max. drill diameter (Steel)
| 10 mm
Weight
| 1.9 kg
Lpa (sound pressure)
| 90 dB(A)
Lwa (sound power)
| 103 dB(A)
Vibration value
| 10.8 m/s
2
Push
3