PURSUIT DENALI 24, Руководство пользователя

Страница: 42 / 132

Denali 24
For example: When the switch is on battery # 1, the engine and the 12-volt system will be supplied
power by battery # 1. Battery # 2 will be isolated and in reserve. Battery # 1 will be charged by
the alternator. When the selector switch is on battery # 2, the engine and the 12-volt system will
be supplied power by battery # 2. Battery # 1 will be isolated and in reserve. Battery # 2 will then
be charged by the alternator.
When the selector switch is on “ALL,” the batteries are connected in parallel so the engine and the
12-volt system will be supplied power by both batteries. Both batteries will be charged by the
alternator. The “ALL” position should only be used when starting the engine, as this requires extra
electrical power, or when both batteries are low and need charging. Otherwise, it is recommended
that the selector switch be set on battery # 1 or battery # 2 when the engine is operating. While in
port, or at anchor, the battery selector switch should be on either the battery # 1 or the battery # 2
position. This will keep one battery in reserve for starting the engine. The battery switch should
be turned to the “OFF” position when leaving the boat unattended.
12-volt Accessory Switch Panels
The main accessory switch panel is located at the helm. The circuit breakers that protect the
accessories are located near the switches.
The following is a description of the accessories controlled by the main accessory switch panel:
Horn
Activates the boat horn.
Bilge Blower
This switch supplies electrical current to the blower that provides ventilation to the engine
compartment prior to start up and while operating below cruise speed.
12-volt Accessory Switch Panel
4-2