PURSUIT DENALI 24, Руководство пользователя

Страница: 51 / 132

Denali 24
Chapter 6:
RAW WATER SYSTEM
6.1 General
In the raw or sea water systems, all water pumps are supplied by a hose connected to a ball valve
and thru hull fitting located in the bilge compartment. Always make sure the ball valves are open
before attempting to operate any component of the raw water system.
12-volt pumps supply sea water to the most accessories.
Priming the System
Make sure the thru hull ball valves are open. Open the hose connector for the raw water washdown
and activate the pressure pump by turning the washdown pump switch to the “ON” position. Run
the pump until all of the air is purged from the system and then turn the switch off. Turn the livewell
switch to the “ON” position. Run the pump until all of the air is purged from the system and then
turn the switch to the “OFF” position.
Note: It may be necessary to reprime the raw water system if the system is not used for an
extended period and at the time of launching.
6-1